My Honda Rs125 side project was neglected for the past few months and I just had the time to make some work on it. The clip on bars looked to be an easy job for a start and a great warm up... both were worn and bended so off they go to the bin!
I've used a 22mm aluminum tube and cut two pieces to the same length as oem bars. At the ends of both bars, I have fitted chair leg end plugs though I'm not really sure if they are ACU approved! LOL
While I was there, I've installed a later model Nissin master cylinder and I think I'm going to use a rear HRC brake hose on the front brake as well. Looks a little bit better now.
Comments
Post a Comment